Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › SIDE AIRBAG SENSOR

SIDE AIRBAG SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL SIDE AIRBAG SENSOR
  1. Check that the ignition switch is off.

  1. Check that the battery negative (-) cable is disconnected.

    CAUTION:
    Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.



    C133888
  1. Install the side airbag sensor with the bolt.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

    NOTICE:
    1. If the side airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
    2. When installing the side airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

  1. Check that there is no looseness in the installation parts of the side airbag sensor.

  1. Connect the connector.



2. INSTALL LOWER CENTER PILLAR GARNISH


    B132058
  1. Engage the 2 claws and 2 clips, then install the lower center pillar garnish LH.



3. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP


4. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP


5. INSTALL REAR DOOR SCUFF PLATE


    B132068
  1. Engage the 5 claws and 2 clips, then install the rear door scuff plate LH.



6. INSTALL FRONT DOOR SCUFF PLATE


    B132067
  1. Engage the 7 claws and 3 clips, then install the front door scuff plate LH.



7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


8. INSPECT SRS WARNING LIGHT
  1. Inspect the SRS warning light (Click here).