SIDE AIRBAG SENSOR > INSTALLATION |
| 1. INSTALL SIDE AIRBAG SENSOR |
Check that the ignition switch is off.
Check that the battery negative (-) cable is disconnected.
![]() |
Install the side airbag sensor with the bolt.
Check that there is no looseness in the installation parts of the side airbag sensor.
Connect the connector.
| 2. INSTALL LOWER CENTER PILLAR GARNISH |
![]() |
Engage the 2 claws and 2 clips, then install the lower center pillar garnish LH.
| 3. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP |
![]() |
Install the rear door opening trim weatherstrip LH as shown in the illustration.
| 4. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP |
![]() |
Install the front door opening trim weatherstrip LH as shown in the illustration.
| 5. INSTALL REAR DOOR SCUFF PLATE |
![]() |
Engage the 5 claws and 2 clips, then install the rear door scuff plate LH.
| 6. INSTALL FRONT DOOR SCUFF PLATE |
![]() |
Engage the 7 claws and 3 clips, then install the front door scuff plate LH.
| 7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 8. INSPECT SRS WARNING LIGHT |
Inspect the SRS warning light (Click here).