Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › SIDE AIRBAG SENSOR

SIDE AIRBAG SENSOR > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. PRECAUTION

CAUTION:
Be sure to read "PRECAUTION" thoroughly before servicing (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.



3. REMOVE FRONT DOOR SCUFF PLATE


    B132067
  1. Disengage the 7 claws and 3 clips, and remove the front door scuff plate LH.



4. REMOVE REAR DOOR SCUFF PLATE


    B132068
  1. Disengage the 5 claws and 2 clips, and remove the rear door scuff plate LH.



5. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP


6. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP


7. REMOVE LOWER CENTER PILLAR GARNISH


    B132057
  1. Disengage the 2 claws and 2 clips, and remove the lower center pillar garnish LH.



8. REMOVE SIDE AIRBAG SENSOR


    C133888
  1. Remove the bolt and side airbag sensor from the body.

  1. Disconnect the connector from the side airbag sensor.