Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › FRONT AIRBAG SENSOR

FRONT AIRBAG SENSOR > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. PRECAUTION

CAUTION:
Be sure to read "PRECAUTION" thoroughly before servicing (Click here).

NOTICE:
w/ Navigation System for HDD:
After the ignition switch is turned off, the navigation receiver assembly (HDD navigation system) records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.



3. REMOVE ENGINE UNDER COVER RH


4. REMOVE ENGINE UNDER COVER LH


5. REMOVE FRONT AIRBAG SENSOR


    C133886
  1. Remove the bolt and front airbag sensor from the body.

  1. Disconnect the connector from the front airbag sensor.