SLIDING ROOF SYSTEM > Sliding Roof Control Switch Circuit |
| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SLIDING ROOF OPERATION) |
Select the ACTIVE TEST, use the intelligent tester to generate a control command, and then check that the sliding roof slides open/close and tilts up/down.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Slide Roof (Slide Roof) | Operate sliding roof SLIDE CLOSE/TILT UP | CLOS/UP: Sliding roof SLIDE CLOSE or TILT UP operation occurs. OFF: Sliding roof is not operating | - |
| Slide Roof (Slide Roof) | Operate sliding roof SLIDE OPEN/TILT DOWN | OPN/DWN: Sliding roof SLIDE OPEN or TILT DOWN operation occurs OFF: Sliding roof is not operating | - |
|
| ||||
| OK | |
| 2.READ VALUE USING INTELLIGENT TESTER (SLIDING ROOF SWITCH) |
Use the DATA LIST to check if the sliding roof switch is functioning properly.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Open SW (Open Switch) | Slide switch open signal/ON or OFF | ON: OPEN switch is pressed. OFF: OPEN switch is not pressed. | - |
| Close SW (Close Switch) | Slide switch close signal/ON or OFF | ON: CLOSE switch is pressed. OFF: CLOSE switch is not pressed. | - |
| Up SW (Up Switch) | Tilt switch up signal/ON or OFF | ON: UP switch is pressed. OFF: UP switch is not pressed. | - |
| Down SW (Down Switch) | Tilt switch down signal/ON or OFF | ON: DOWN switch is pressed. OFF: DOWN switch is not pressed. | - |
|
| ||||
| NG | |
| 3.CHECK WIRE HARNESS (SLIDING ROOF CONTROL ECU - ROOF CONSOLE BOX ASSEMBLY) |
![]() |
Disconnect the Q12 and Q6 connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Q12-2 (E) - Q6-3 (GND) | Always | Below 1 Ω |
| Q12-7 (OPN) - Q6-2 (OPN) | Always | Below 1 Ω |
| Q12-8 (DWN) - Q6-4 (DOWN) | Always | Below 1 Ω |
| Q12-9 (CLS) - Q6-1 (CLS) | Always | Below 1 Ω |
| Q12-10 (UP) - Q6-5 (UP) | Always | Below 1 Ω |
| Q6-1 (CLS) - Body ground | Always | 10 kΩ or higher |
| Q6-2 (OPN) - Body ground | Always | 10 kΩ or higher |
| Q6-3 (GND) - Body ground | Always | Below 1 Ω |
| Q6-4 (DOWN) - Body ground | Always | 10 kΩ or higher |
| Q6-5 (UP) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||