CRUISE CONTROL SYSTEM > TC and CG Terminal Circuit |

| 1.CHECK WIRE HARNESS (TERMINAL TC of DLC3 - ECM) |
![]() |
Disconnect the A55 connector from the ECM. (2GR-FE (LHD))
Disconnect the A24 connector from the ECM. (2AZ-FE, 2GR-FE (RHD))
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A55-27 (TC) - E10-13 (TC)*1
A24-27 (TC) - E10-13 (TC)*2 | Always | Below 1 Ω |
|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (TERMINAL CG of DLC3 - BODY GROUND) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester connection | Condition | Specified condition |
| E10-4 (CG) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK WIRE HARNESS (TERMINAL TC of DLC3 - BODY GROUND) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E10-13 (TC) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||