DTC B1451/51 Compressor Solenoid Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1451/51 | Open or short in solenoid of the externally changeable compressor circuit |
|

| 1.INSPECT A/C COMPRESSOR |
![]() |
Disconnect the A/C compressor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C21-2 (SOL+) - C21-1 (SOL-) | 20°C (68°F) | 10 to 11 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (A/C COMPRESSOR - BODY GROUND) |
![]() |
Disconnect the A/C compressor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C21-1 (SOL-) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (A/C COMPRESSOR - A/C AMPLIFIER) |
![]() |
Disconnect the A/C compressor connector.
![]() |
Disconnect the A/C amplifier connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E38-2 (SOL+) - C21-2 (SOL+) | Always | Below 1 Ω |
| E38-2 (SOL+) - Body ground | Always | 10 kΩ or higher |
| Result | Proceed to |
| NG | A |
| OK (When troubleshooting according to the PROBLEM SYMPTOMS TABLE) | B |
| OK (When troubleshooting according to the DTC) | C |
|
| ||||
|
| ||||
| A | ||
| ||