Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM

DTC    B1497/97    BUS IC Communication Malfunction

for Preparation Click here


DESCRIPTION

The air conditioning harness connects the air conditioning amplifier and each servo motor. The air conditioning amplifier supplies power and sends operation instructions to each servo motor through the air conditioning harness. Each servo motor sends the damper position information to the air conditioning amplifier.

DTC No.
DTC Detection Condition
Trouble Area
B1497/97
Communication line error or open
  1. Air conditioning harness
  2. A/C amplifier

WIRING DIAGRAM


E130105E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR
  1. Remove the A/C amplifier.



    E124470E11
  1. Disconnect the connector from the A/C amplifier.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E38-14 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT AIR CONDITIONING AMPLIFIER


    E124471E04
  1. Reconnect the connector to the A/C amplifier.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    e1-2 (BUS G) - E38-14 (GND)
    Always
    Below 1 Ω



NG
REPLACE AIR CONDITIONING AMPLIFIER
OK


3.INSPECT AIR CONDITIONING AMPLIFIER


    E124471E10
  1. Disconnect the connector (e1) from the A/C amplifier .

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    e1-4 (B BUS) - Body ground
    Ignition switch: LOCK
    Below 1 V
    e1-4 (B BUS) - Body ground
    Ignition switch: ON
    10 to 14 V



NG
REPLACE AIR CONDITIONING AMPLIFIER
OK


4.REPLACE AIR CONDITIONING HARNESS
  1. Replace the air conditioning harness.

    HINT:
    Since the air conditioning harness cannot be inspected while it is removed from the vehicle, replace the air conditioning harness with a normal one and check that the condition returns to normal.

  1. Check for DTCs.

    Result:
    Result
    Proceed to
    DTC B1497/97 is output.
    A
    DTC B1497/97 is not output.
    B



B
END
A

REPLACE AIR CONDITIONING AMPLIFIER