FRONT SEAT SIDE AIRBAG ASSEMBLY (for Power Seat) > REMOVAL |
| 1. REMOVE FRONT SEAT HEADREST ASSEMBLY |
| 2. REMOVE SEAT TRACK COVER |
Operate the power seat switch knob and move the seat to the position farthest forward.
![]() |
Using a screwdriver, detach the 4 claws and remove the seat track cover.
| 3. REMOVE INNER SEAT TRACK BRACKET COVER |
![]() |
Using a screwdriver, detach the 4 claws and remove the inner seat track bracket cover.
| 4. REMOVE FRONT SEAT ASSEMBLY |
Operate the power seat switch knob and move the seat to the rearmost position.
![]() |
Remove the 2 bolts on the front seat track bracket.
Operate the power seat switch knob and move the seat to the position farthest forward.
![]() |
Remove the 2 bolts on the rear seat track bracket.
Disconnect the cable from the negative (-) battery terminal.
Disconnect the connectors under the seat. Then remove the front seat assembly.
| 5. REMOVE RECLINING POWER SEAT SWITCH KNOB |
![]() |
Using a screwdriver, detach the reclining power seat switch knob.
| 6. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB |
![]() |
Using a screwdriver, detach the slide and vertical power seat switch knob.
| 7. REMOVE FRONT SEAT CUSHION SHIELD ASSEMBLY |
![]() |
Disconnect the 2 hooks.
![]() |
Remove the 5 screws.
Disengage the claw and separate the front seat cushion shield assembly.
Disconnect the connector from the front power seat lumbar switch.
| 8. REMOVE FRONT SEAT INNER BELT ASSEMBLY |
![]() |
for Driver seat:
Disconnect the connectors and disengage the 4 clamps.
for Passenger seat:
Disconnect the connector and disengage the 3 clamps.
![]() |
Remove the nut and front seat inner belt assembly.
| 9. REMOVE FRONT INNER SEAT CUSHION SHIELD |
![]() |
Remove the screw.
Using a clip remover, detach the clip.
Using a screwdriver, detach the claw and remove the front inner seat cushion shield.
| 10. REMOVE FRONT SEAT BACK BOARD SUB-ASSEMBLY |
![]() |
Remove the 2 screws.
Disconnect the 14 clamps and front separate type seatback cover.
Pull the seatback board in the direction indicated by the arrow in the illustration to detach the 2 claws. Then, remove the seatback board.
| 11. REMOVE FRONT SEAT HEADREST SUPPORT (for LH Side) |
![]() |
Detach the 2 claws and remove the headrest support.
| 12. REMOVE FRONT SEAT HEADREST SUPPORT (for RH Side) |
| 13. REMOVE FRONT SEPARATE TYPE SEAT BACK ASSEMBLY |
![]() |
Remove the 2 hog rings and 3 hooks.
![]() |
Remove the nut and 2 seatback cover brackets.
Remove the front separate type seatback cover with pad.
| 14. REMOVE FRONT SEAT SIDE AIRBAG ASSEMBLY |
![]() |
Disconnect the 4 wire harness clamps from under the seat.
![]() |
Disconnect the 2 clamps.
Remove the 2 nuts and the front seat side airbag assembly.