FRONT SEAT ASSEMBLY (for Power Seat) > REASSEMBLY |
| 1. INSTALL FRONT SEAT WIRE |
| 2. INSTALL SEAT POSITION SENSOR (for Driver Side) |
Check that the ignition switch is off.
Check that the negative battery (-) cable is disconnected.
![]() |
Engage the pin and install the seat position sensor to the seat slide position sensor protector as shown in the illustration.
![]() |
Using a feeler gauge 1.0 mm (0.039 in.), temporarily install the seat position sensor.
![]() |
Using a "TORX" socket (T30), tighten the "TORX" screw to install the seat position sensor.
Make sure that a clearance between the seat position sensor and the seat rail is within 0.6 mm (0.024 in.) to 1.4 mm (0.055 in.).
Check that there is no looseness in the installation parts of the seat position sensor.
Connect the connector.
| 3. INSTALL FRONT LOWER SEAT CUSHION SHIELD |
| 4. INSTALL FRONT LOWER SEAT CUSHION SHIELD LH |
| 5. INSTALL SEAT RECLINING ADJUSTER INSIDE COVER LH |
| 6. INSTALL SEAT RECLINING ADJUSTER INSIDE COVER RH |
| 7. INSTALL RECLINING ADJUSTER INSIDE COVER LH |
| 8. INSTALL RECLINING ADJUSTER INSIDE COVER RH |
| 9. INSTALL FRONT SEAT SIDE AIRBAG ASSEMBLY |
![]() |
Install the front seat side airbag assembly with 2 new nuts.
![]() |
Connect the 2 clamps.
Connect the 4 wire harness clamps to under the seat.
| 10. INSTALL LUMBAR SUPPORT ADJUSTER ASSEMBLY |
| 11. INSTALL FRONT SEPARATE TYPE SEATBACK COVER |
![]() |
Using hog ring pliers, install the front separate type seatback cover to the front seatback pad with 16 new hog rings.
| 12. INSTALL FRONT SEPARATE TYPE SEATBACK ASSEMBLY |
![]() |
Fully cover the airbag with the 2 seatback cover brackets and tighten the nut.
![]() |
Engage the 3 hooks.
Using hog ring pliers, install 2 new hog rings.
| 13. INSTALL FRONT SEAT HEADREST SUPPORT |
| 14. INSTALL FRONT SEAT HEADREST SUPPORT |
| 15. INSTALL FRONT SEATBACK BOARD SUB-ASSEMBLY |
| 16. INSTALL FRONT SEPARATE TYPE SEAT CUSHION COVER |
![]() |
Using hog ring pliers, install the front separate type seat cushion cover to the front separate type seat pad with 16 new hog rings.
| 17. INSTALL FRONT SEPARATE TYPE SEAT CUSHION COVER WITH PAD |
| 18. INSTALL FRONT POWER SEAT SWITCH |
| 19. INSTALL LOWER SEAT TRACK SPACER |
| 20. INSTALL FRONT INNER SEAT CUSHION SHIELD |
| 21. INSTALL FRONT LUMBAR POWER SEAT SWITCH |
| 22. INSTALL FRONT SEAT INNER BELT ASSEMBLY |
![]() |
Install the front seat inner belt assembly with the nut.
![]() |
for Driver seat:
Connect the connectors and engage the 4 clamps.
for Passenger seat:
Connect the connector and engage the 3 clamps.
| 23. INSTALL FRONT INNER NO. 1 SEAT CUSHION SHIELD |
| 24. INSTALL FRONT SEAT CUSHION SHIELD ASSEMBLY |
| 25. INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB |
| 26. INSTALL RECLINING POWER SEAT SWITCH KNOB |