FRONT SEAT SIDE AIRBAG ASSEMBLY (for Power Seat) > INSTALLATION |
| 1. INSTALL FRONT SEAT SIDE AIRBAG ASSEMBLY |
![]() |
Install the front seat side airbag assembly with 2 new nuts.
![]() |
Connect the 2 clamps.
Connect the 4 wire harness clamps to under the seat.
| 2. INSTALL FRONT SEPARATE TYPE SEAT BACK ASSEMBLY |
![]() |
Fully cover the airbag with the 2 seatback cover brackets and tighten the nut.
![]() |
Engage the 3 hooks.
Using hog ring pliers, install 2 new hog rings.
| 3. INSTALL FRONT SEAT HEADREST SUPPORT (for LH Side) |
| 4. INSTALL FRONT SEAT HEADREST SUPPORT (for RH Side) |
| 5. INSTALL FRONT SEAT BACK BOARD SUB-ASSEMBLY |
| 6. INSTALL FRONT INNER SEAT CUSHION SHIELD |
| 7. INSTALL FRONT SEAT INNER BELT ASSEMBLY |
![]() |
Install the front seat inner belt assembly with the nut.
![]() |
for Driver seat:
Connect the connectors and engage the 4 clamps.
for Passenger seat:
Connect the connector and engage the 3 clamps.
| 8. INSTALL FRONT SEAT CUSHION SHIELD ASSEMBLY |
| 9. INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB |
| 10. INSTALL RECLINING POWER SEAT SWITCH KNOB |
| 11. INSTALL FRONT SEAT ASSEMBLY |
Place the seat in the cabin.
Connect the connectors under the seat.
Connect the cable to the negative (-) battery terminal.
Move the front seat assembly fully forward by operating the slide and vertical power seat switch knob.
![]() |
Temporarily install the front side of the front seat assembly with the 2 bolts.
Move the front seat assembly fully forward by operating the slide and vertical power seat switch knob.
![]() |
Temporarily install the rear side of the front seat assembly with the 2 bolts.
Move the front seat assembly to the rearmost position by operating the slide and vertical power seat switch knob.
Fully tighten the 2 bolts on the front side of the front seat assembly in the order of the inner side bolt and then the outer side bolt.
Move the front seat assembly fully forward by operating the slide and vertical power seat switch knob.
Fully tighten the 2 bolts on the rear side of the front seat assembly in the order of the inner side bolt and then the outer side bolt.
| 12. INSTALL INNER SEAT TRACK BRACKET COVER |
![]() |
Slide the inner seat track bracket cover along the seat rail toward the front of the vehicle. Engage claw A to the seat rail.
Push the inner seat track bracket cover to engage claw B.
| 13. INSTALL SEAT TRACK COVER |
![]() |
Slide the seat track cover along the seat rail toward the front of the vehicle. Engage claw A to the seat rail.
Push the seat track cover to engage claw B.
| 14. INSTALL FRONT SEAT HEADREST ASSEMBLY |
| 15. CHECK SRS WARNING LIGHT |
Inspect the SRS warning light (Click here).
| 16. INSPECT FRONT SEAT ASSEMBLY |
Check the power seat operation.
Check the seat heater operation (with seat heater system).
Turn the ignition switch on (IG).
Turn the seat heater switch ON.
Wait 5 minutes or more and confirm that the seat surface becomes warm.