DTC P0443 Evaporative Emission Control System Purge Control Valve Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0443 | Both of the following conditions (a) and (b) are met (1 trip detection logic) (a) The target control value and actual control value do not match for 10 seconds or more. (b) The target control value and actual control value do not match for 80 times or more. |
|

| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (ACTIVATE THE PURGE VSV CONTROL) |
![]() |
Connect the intelligent tester to the DLC3.
Disconnect the charcoal canister side vacuum hose from the purge VSV.
Start the engine.
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Activate the VSV for Evap Control.
When the purge VSV is operated using the tester, check whether the port of the purge VSV applies suction to your finger.
| Tester Operation | Specified Condition |
| ON (Purge VSV is on) | Purge VSV port applies suction to finger |
| OFF (Purge VSV is off) | Purge VSV port applies no suction to finger |
Reconnect the vacuum hose to the purge VSV.
|
| ||||
| OK | ||
| ||
| 2.INSPECT PURGE VSV |
Inspect the purge VSV (Click here).
|
| ||||
| OK | |
| 3.CHECK PURGE VSV (POWER SOURCE VOLTAGE) |
![]() |
Disconnect the purge VSV connector.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| C6-1 - Body ground | Ignition switch ON | 11 to 14 V |
| *1 | Front view of wire harness connector (to Purge VSV) |
Reconnect the purge VSV connector.
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (PURGE VSV - ECM) |
Disconnect the purge VSV connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C6-2 - C24-49 (PRG) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| C6-2 or C24-49 (PRG) - Body ground | Always | 10 kΩ or higher |
Reconnect the purge VSV connector.
Reconnect the ECM connector.
|
| ||||
| OK | ||
| ||