AUTOMATIC TRANSAXLE SYSTEM > DTC CHECK / CLEAR |
| CHECK DTC |
![]() |
DTCs which are stored in the ECM can be displayed with the intelligent tester and generic OBD scan tool.
These scan tools can display pending DTCs and current DTCs. Some DTC aren't stored if the ECM doesn't detect a malfunction during consecutive driving. However, the detected malfunction during once driving is stored as pending DTC.
Connect the intelligent tester to the Data Link Connector 3 (DLC3).
Turn the ignition switch to the ON position.
Enter the following menus: Enter / Powertrain / ECT / DTC / Current (or Pending).
Confirm the DTCs and freeze frame data and then write them down.
Confirm the details of the DTCs (Click here).
| CLEAR DTC WITH INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Enter the following menus: Enter / Powertrain / ECT / DTC / Clear.