AUTOMATIC TRANSAXLE SYSTEM > DTC CHECK / CLEAR |
| CHECK DTC |
![]() |
DTCs which are stored in the TCM can be displayed with the intelligent tester.
These scan tools can display pending DTCs and current DTCs. Some DTCs are not stored if the TCM doesn't detect a malfunction during consecutive driving. However, the malfunction detected while a driving is stored as a pending DTC.
Connect the intelligent tester to the Data Link Connector 3 (DLC3).
Turn the ignition switch on.
Enter the following menus: Powertrain / ECT / DTC.
Confirm the DTCs and freeze frame data and then write them down.
Confirm the details of the DTCs (Click here).
| CLEAR DTC |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on.
Enter the following menus: Powertrain / ECT / DTC / Clear.