AUTOMATIC TRANSAXLE SYSTEM > CHECK MODE PROCEDURE |
| DESCRIPTION |
Check mode has a higher sensitivity to malfunctions and can detect malfunctions that normal mode cannot detect. Check mode can also detect all the malfunctions that normal mode can detect. In check mode, DTCs are detected with 1-trip detection logic.
| CHECK MODE PROCEDURE |
![]() |
Make sure that the items below are satisfied:
Battery positive voltage is 11 V or more
Throttle valve is fully closed
Transaxle is in the P or N position
A/C is switched OFF
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch on.
Enter the following menus: Powertrain / ECT / Check Mode.
![]() |
Change the ECM to check mode. Make sure that the MIL flashes as shown in the illustration.
Start the engine. The MIL should turn off after the engine starts.
Perform "MONITOR DRIVE PATTERN" for the ECT test (Click here).
(Or, duplicate the conditions of the malfunction described by the customer).
After duplicating the malfunction conditions, use the intelligent tester diagnosis selector to check the DTC and freeze frame data.