AUTOMATIC TRANSAXLE SYSTEM > ROAD TEST |
| PROBLEM SYMPTOM CONFIRMATION |
Based on the result of the customer problem analysis, try to reproduce the symptoms. If the problem is that the transaxle does not shift up or down, or the shift point is too high or too low, conduct the following road test referring to the automatic shift schedule and attempt to duplicate the problem symptoms.
| ROAD TEST |
D position test:
Shift into the D position and fully depress the accelerator pedal and check the following:
Check up-shift operation.
Check that the 1st to 2nd, 2nd to 3rd, 3rd to 4th, 4th to 5th and 5th to 6th up-shifts take place, and that the shift points conform to the automatic shift schedule (Click here).
Check for shift shock and slip.
Check for shock and slip at the 1st to 2nd, 2nd to 3rd, 3rd to 4th, 4th to 5th and 5th to 6th up-shifts.
Check for abnormal noise and vibration.
Check for abnormal noise and vibration when up-shifting from 1st to 2nd, 2nd to 3rd, 3rd to 4th, 4th to 5th and 5th to 6th while driving with the shift lever in the D position, and also while driving in the lock-up condition.
Check kick-down operation.
Check vehicle speeds when the 6th to 5th, 5th to 4th, 4th to 3rd, 3rd to 2nd, and 2nd to 1st kick-downs take place while driving with the shift lever in the D position. Confirm that each speed is within the applicable vehicle speed range indicated in the automatic shift schedule (Click here).
Check for abnormal shock and slip at kick-down.
Check the lock-up mechanism.
S position test
Shift to the S position, depress the accelerator pedal and check the following:
Check shift operation.
R position test:
Shift into the R position, lightly depress the accelerator pedal, and check that the vehicle moves backward without any abnormal noise or vibration.
P position test:
Stop the vehicle on a grade (more than 5°) and after shifting into the P position, release the parking brake. Then, check that the parking lock pawl holds the vehicle in place.