AUTOMATIC TRANSAXLE SYSTEM > HYDRAULIC TEST |
| PERFORM HYDRAULIC TEST |
![]() |
Measure the line pressure.
Warm up the ATF (Automatic Transmission Fluid).
Lift the vehicle up.
Remove the engine under cover.
Connect the intelligent tester to the DLC3.
Remove the test plug on the transaxle case front left side and install the SST.
Start the engine.
Shift to the D position, and then use the intelligent tester to hold 3rd gear using active test. Measure the line pressure while the engine is idling.
| Condition | D position kPa (kgf/cm2, psi) |
| Idling | 360 to 430 kPa (3.7 to 4.4 kgf/cm2, 52 to 62 psi) |
Turn the ignition switch OFF.
![]() |
Disconnect the connector of the TCM.
Start the engine.
Firmly depress the brake pedal, shift to the D position, depress the accelerator pedal all the way down, and check the line pressure while the stall test is performed.
| Condition | D position kPa (kgf / cm2, psi) |
| Stall test | 1160 to 1350 kPa (11.8 to 13.8 kgf/cm2, 168 to 196 psi) |
Turn the ignition switch OFF.
Connect the TCM connector, depress the brake pedal firmly, shift to the R position, and check the line pressure while the engine is idling and during the stall test.
| Condition | R position kPa (kgf / cm2, psi) |
| Idling | 800 to 950 kPa (8.2 to 9.7 kgf/cm2, 116 to 138 psi) |
| Stall test | 1900 to 2200 kPa (19.4 to 22.4 kgf/cm2, 276 to 319 psi) |
Remove the SST, and install the test plug.
Clear the DTC.
| Problem | Possible cause |
| Measured values are higher than the specified value in all positions |
|
| Measured values are lower than the specified value in all positions |
|
| Pressure is low in the D position only |
|
| Pressure is low in the R position only |
|