DTC P0711 Transmission Fluid Temperature Sensor "A" Performance |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0711 | (A) Both (a) and (b) are detected: (2-trip detection logic) (a) Intake air and engine coolant temperatures are more than -10°C (14°F) at engine start (b) After normal driving for over 19 min. and 8 km (5 mile) or more, ATF temp. is less than 20°C (68°F) (B) When engine coolant temp. is less that 35°C (95°F) at engine start, the ATF temp. is 110°C (230°F) or more after 17 min. of engine start (2-trip detection logic). | Transmission wire (ATF temperature sensor) |

| DATA LIST |
Warm up the engine.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn on the tester.
Select the item "Enter / Powertrain / ECT / Data List".
Follow the instructions on the tester and read the Data List.
| Item | Measurement Item/ Range (display) | Normal Condition |
| A/T Oil Temperature 1 | ATF Temp. Sensor Value/ min.: -40°C (-40°F) max.: 215°C (419°F) | Approx. 80°C (176°F) (After Stall Test) |
| Temperature Displayed | Malfunction |
| -40°C (-40°F) | Open circuit |
| 150°C (302°F) or more | Short circuit |
| 1.CHECK OTHER DTCS OUTPUT (IN ADDITION TO DTC P0711) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn on the tester.
Select the item "Powertrain / ECT / DTC / Current or Pending".
Read the DTCs using the intelligent tester.
| Display (DTC output) | Proceed to |
| Only "P0711" is output | A |
| "P0711" and other DTCs | B |
|
| ||||
| A | |
| 2.CHECK TRANSMISSION FLUID LEVEL |
|
| ||||
| OK | ||
| ||