DTC P0724 Brake Switch "B" Circuit High |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0724 | Stop light switch remains ON even when vehicle is driven in GO (30 km/h (18.63 mph) or more) and STOP (less than 3 km/h (1.86 mph)) pattern 5 times (2 trip detection logic) |
|

| 1.INSPECT STOP LIGHT SWITCH |
![]() |
Disconnect the A19 stop light switch connector.
Remove the stop light switch.
Measure the resistance between the terminals.
| Tester Connection | Switch Position | Specified Condition |
| 1 - 2 | Switch pin not pushed | Below 1 Ω |
| Switch pin pushed | 10 kΩ or higher | |
| 3 - 4 | Switch pin not pushed | 10 kΩ or higher |
| Switch pin pushed | Below 1 Ω |
Reinstall the stop light switch.
Reconnect the stop light switch connector.
|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (ECM - BATTERY) |
![]() |
Measure the voltage of the wire harness side connector.
Disconnect the A24 ECM connector.
Measure the voltage.
| Tester Connection | Condition | Specified Condition |
| STP (A24-36) - Body ground | Brake pedal is depressed | 9 to 14 V |
| STP (A24-36) - Body ground | Brake pedal is released | Below 1.5 V |
Reconnect the ECM connector.
|
| ||||
| OK | ||
| ||