Home › ENGINE ยท 2GR-FE › ENGINE CONTROL SYSTEM › SFI SYSTEM

DTC    P0604    Internal Control Module Random Access Memory (RAM) Error

DTC    P0606    ECM / PCM Processor

DTC    P0607    Control Module Performance

DTC    P060A    Internal Control Module Monitoring Processor Performance

DTC    P060D    Internal Control Module Accelerator Pedal Position Performance

DTC    P060E    Internal Control Module Throttle Position Performance

DTC    P0657    Actuator Supply Voltage Circuit / Open

DTC    P1607    Cruise Control Input Processor

for Preparation Click here


DESCRIPTION

The ECM continuously monitors its internal memory status, internal circuits, and output signals sent to the throttle actuator. This self-check ensures that the ECM is functioning properly. If any malfunction is detected, the ECM will set the appropriate DTC and illuminate the MIL.
The ECM memory status is diagnosed by internal "mirroring" of the main CPU and the sub CPU to detect Random Access Memory (RAM) errors. The 2 CPUs also perform continuous mutual monitoring. The ECM illuminates the MIL and sets a DTC if: 1) outputs from the 2 CPUs are different and deviate from the standards, 2) the signals sent to the throttle actuator deviate from the standards, 3) a malfunction is found in the throttle actuator supply voltage, and 4) any other ECM malfunction is found.

DTC No.
DTC Detection Condition
Trouble Area
P0604
P0606
P0607
P060A
P060D
P060E
P0657
P1607
ECM internal error (1 trip detection logic)
ECM

INSPECTION PROCEDURE

HINT:
Read freeze frame data using the intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was running or stopped, whether the engine was warmed up or not, whether the air-fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction (Click here).

1.CHECK OTHER DTC OUTPUT
  1. Connect the intelligent tester to the DLC3.

  1. Turn the engine switch on (IG) and turn the tester on.

  1. Clear the DTCs.

  1. Turn the ignition switch off and turn the tester off.

  1. Disconnect the intelligent tester.

  1. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

  1. Connect the cable to the negative (-) battery terminal.

  1. Connect the intelligent tester to the DLC3.

  1. Turn the engine switch on (IG) and turn the tester on.

  1. Enter the following menus: Powertrain / Engine and ECT / DTC.

  1. Read the DTCs.


Result:

Result
Proceed to
DTC P0604, P0606, P0607, P060A, P060D, P060E, P0657 and/or P1607 are output
A
DTC P0604, P0606, P0607, P060A, P060D, P060E, P0657, P1607 and other DTCs are output
B
DTC is not output
C



B
GO TO DTC CHART (Click here)

C
CHECK FOR INTERMITTENT PROBLEMS (Click here)
A

REPLACE ECM (Click here)