DTC P0604 Internal Control Module Random Access Memory (RAM) Error |
DTC P0606 ECM / PCM Processor |
DTC P0607 Control Module Performance |
DTC P060A Internal Control Module Monitoring Processor Performance |
DTC P060D Internal Control Module Accelerator Pedal Position Performance |
DTC P060E Internal Control Module Throttle Position Performance |
DTC P0657 Actuator Supply Voltage Circuit / Open |
DTC P1607 Cruise Control Input Processor |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0604 P0606 P0607 P060A P060D P060E P0657 P1607 | ECM internal error (1 trip detection logic) | ECM |
| 1.CHECK OTHER DTC OUTPUT |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG) and turn the tester on.
Clear the DTCs.
Turn the ignition switch off and turn the tester off.
Disconnect the intelligent tester.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG) and turn the tester on.
Enter the following menus: Powertrain / Engine / DTC.
Read the DTCs.
| Result | Proceed to |
| DTC P0604, P0606, P0607, P060A, P060D, P060E, P0657 and/or P1607 are output | A |
| DTC P0604, P0606, P0607, P060A, P060D, P060E, P0657, P1607 and other DTCs are output | B |
| DTC is not output | C |
|
| ||||
|
| ||||
| A | ||
| ||