STEERING COLUMN ASSEMBLY > REASSEMBLY |
| 1. INSTALL IGNITION OR STARTER SWITCH ASSEMBLY |
![]() |
Engage the 2 claws to install the ignition or starter switch assembly to the steering lock sub-assembly.
| 2. INSTALL KEY INTERLOCK SOLENOID (for Automatic Transaxle) |
![]() |
Install the key interlock solenoid to the steering lock sub-assembly with the 2 screws.
| 3. INSTALL UN-LOCK WARNING SWITCH ASSEMBLY |
![]() |
Engage the 2 claws to install the un-lock warning switch assembly to the steering lock sub-assembly.
| 4. INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY |
Make sure that the ignition switch lock cylinder assembly is in the ACC position.
![]() |
Install the ignition switch lock cylinder assembly to the steering lock sub-assembly.
Make sure that the ignition switch lock cylinder assembly is securely installed.
| 5. INSPECT STEERING LOCK OPERATION |
![]() |
Check that the steering lock mechanism is activated when the key is removed.
![]() |
Check that the steering lock mechanism is deactivated when the key is inserted and turned to the ACC position.
| 6. INSTALL STEERING COLUMN UPPER WITH SWITCH BRACKET ASSEMBLY |
Temporarily install the assembled steering lock and its bracket to the steering column assembly using 2 new tapered-head bolts.
![]() |
Tighten the 2 tapered-head bolts until the bolt heads break off.
| 7. INSTALL TRANSPONDER KEY AMPLIFIER |
Align the transponder key amplifier with the upper bracket. Tilt the amplifier slightly and slide it into position.
![]() |
Push the transponder key amplifier to install it to the upper bracket.