Home › STEERING › STEERING COLUMN › STEERING COLUMN ASSEMBLY

STEERING COLUMN ASSEMBLY > REASSEMBLY

for Preparation Click here



1. INSTALL IGNITION OR STARTER SWITCH ASSEMBLY (w/o Entry and Start System)


    C104552E03
  1. Engage the 2 claws to install the ignition or starter switch assembly to the steering lock sub-assembly.



2. INSTALL KEY INTERLOCK SOLENOID (for Automatic Transaxle without Entry and Start System)


    C104553
  1. Install the key interlock solenoid to the steering lock sub-assembly with the 2 screws.



3. INSTALL UN-LOCK WARNING SWITCH ASSEMBLY (w/o Entry and Start System)


    C104837E02
  1. Engage the 2 claws to install the un-lock warning switch assembly to the steering lock sub-assembly.



4. INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY (w/o Entry and Start System)
  1. Make sure that the ignition switch lock cylinder assembly is in the ACC position.



    C103932E02
  1. Install the ignition switch lock cylinder assembly to the steering lock sub-assembly.

  1. Make sure that the ignition switch lock cylinder assembly is securely installed.



5. INSPECT STEERING LOCK OPERATION (w/o Entry and Start System)


    C103934
  1. Check that the steering lock mechanism is activated when the key is removed.



    C103935E02
  1. Check that the steering lock mechanism is deactivated when the key is inserted and turned to the ACC position.

    HINT:
    If there is any abnormality, replace the ignition switch lock cylinder assembly.



6. INSTALL STEERING COLUMN UPPER WITH SWITCH BRACKET ASSEMBLY (w/o Entry and Start System)
  1. Temporarily install the assembled steering lock and its bracket to the steering column assembly using 2 new tapered-head bolts.



    C141490
  1. Tighten the 2 tapered-head bolts until the bolt heads break off.



7. INSTALL TRANSPONDER KEY AMPLIFIER (w/o Entry and Start System)
  1. Align the transponder key amplifier with the upper bracket. Tilt the amplifier slightly and slide it into position.



    C115570
  1. Push the transponder key amplifier to install it to the upper bracket.

    NOTICE:
    Do not push the amplifier with excessive force.



8. INSTALL STEERING LOCK ACTUATOR ASSEMBLY (w/ Entry and Start System)
  1. Temporarily install the steering lock actuator assembly and the steering lock bracket with 2 new tapered-head bolts.



    C103937
  1. Tighten the 2 tapered-head bolts until the bolt heads break off.