TOYOTA PARKING ASSIST-SENSOR SYSTEM > DIAGNOSIS SYSTEM |
| DESCRIPTION |
When troubleshooting a vehicle with a diagnosis system, the only difference from the usual troubleshooting procedure is connecting the intelligent tester to the vehicle and reading various data output from the vehicle clearance warning ECU.
The clearance warning ECU records DTCs when the ECU detects a malfunction in the ECU itself or in its circuits.
To check the DTCs, connect the intelligent tester to the DLC3 on the vehicle. The intelligent tester makes it possible to clear the DTCs, activate the various actuators, and check the freeze frame data and Data List.
| CHECK DLC3 |
![]() |
The ECU uses the ISO 15765-4 for communication protocol. The terminal arrangement of the DLC3 complies with ISO 15031-3 and matches the ISO 15765-4 format.
| Symbols (Terminal No.) | Terminal Description | Condition | Specified Condition |
| CG (4) - Body ground | Chassis ground | Always | Below 1 Ω |
| SG (5) - Body ground | Signal ground | Always | Below 1 Ω |
| BAT (16) - Body ground | Battery positive | Always | 9 to 14 V |
| CANH (6) - CANL (14) | CAN bus line | Ignition switch OFF* | 54 to 69 Ω |
| CANH (6) - Battery positive | HIGH-level CAN bus line | Ignition switch OFF* | 6 kΩ or higher |
| CANH (6) - CG (4) | HIGH-level CAN bus line | Ignition switch OFF* | 200 Ω or higher |
| CANL (14) - Battery positive | LOW-level CAN bus line | Ignition switch OFF* | 6 kΩ or higher |
| CANL (14) - CG (4) | LOW-level CAN bus line | Ignition switch OFF* | 200 Ω or higher |