CAN COMMUNICATION SYSTEM (for LHD) > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.CHECK AND CLEAR DTCS |
| |||||
| 2.CHECK FOR INSTALLED SYSTEMS (ECUS & SENSORS) THAT ADOPT CAN COMMUNICATION |
Check which of the following is adopted: SFI system, automatic transaxle system, brake control system, supplemental restraint system, air conditioning system and meter / gauge system (Click here).
| |||||
| 3.CHECK CAN BUS WIRE |
Check the CAN bus wires. (Click here)
| |||||
| 4.CHECK INTELLIGENT TESTER |
Select "Communication Bus Check" (Click here).
| Symptom | Proceed | See procedure |
| All the ECUs and sensors connected to the CAN communication system are displayed on the screen. | A | Go to step 5 |
| An ECU or sensor not connected to the CAN communication system is displayed on the screen. | B |
Click here
|
| More than one of the ECUs and sensors not connected to the CAN communication system are displayed on the screen. (If the displayed ECUs and sensors are only those relating to the "Engine" and "ECT", proceed to B.) | C |
Click here
|
|
| ||||
|
| ||||
| |||||
| 5.DTC COMBINATION TABLE |
Confirm trouble according to the combination of output DTCs regarding the CAN communication system (Click here).
| |||||
| 6.CIRCUIT INSPECTION |
| |||||
| 7.IDENTIFICATION OF PROBLEM |
| |||||
| 8.REPAIR OR REPLACE |
| |||||
| 9.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|