Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM (for LHD)

CAN COMMUNICATION SYSTEM (for LHD) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


NOTICE:
  1. DTCs for the CAN communication system are as follows: U0101, U0073, U0100, U0123, U0124, U0126, U0129 and B1499.
  2. Refer to troubleshooting of each system if DTCs regarding the CAN communication system are not output.



1.CHECK AND CLEAR DTCS

    NEXT


    2.CHECK FOR INSTALLED SYSTEMS (ECUS & SENSORS) THAT ADOPT CAN COMMUNICATION
    1. Check which of the following is adopted: SFI system, automatic transaxle system, brake control system, supplemental restraint system, air conditioning system and meter / gauge system (Click here).


    NEXT


    3.CHECK CAN BUS WIRE
    1. Check the CAN bus wires. (Click here)


    NEXT


    4.CHECK INTELLIGENT TESTER
    1. Select "Communication Bus Check" (Click here).

      Result:

      Symptom
      Proceed
      See procedure
      All the ECUs and sensors connected to the CAN communication system are displayed on the screen.
      A
      Go to step 5
      An ECU or sensor not connected to the CAN communication system is displayed on the screen.
      B
      Click here
      More than one of the ECUs and sensors not connected to the CAN communication system are displayed on the screen. (If the displayed ECUs and sensors are only those relating to the "Engine" and "ECT", proceed to B.)
      C
      Click here

      NOTICE:
      1. The systems (ECUs, sensors) that adopt CAN communication vary depending on the vehicle and option settings. Check which systems (ECUs, sensors) are installed on the vehicle (Click here).
      2. Non-installed ECUs or sensors are not displayed. Do not mistake ECUs that are not installed as being in communication stop mode.
      3. If 2 or more ECUs or sensors are not displayed on the intelligent tester, perform troubleshooting for communication stop mode for each undisplayed ECU or sensor. (Open in one side of the CAN branch wires.)



    B.
    GO TO "COMMUNICATION STOP MODE TABLE"

    C.
    GO TO "OPEN IN ONE SIDE OF CAN BRANCH WIRE"
    A


    5.DTC COMBINATION TABLE
    1. Confirm trouble according to the combination of output DTCs regarding the CAN communication system (Click here).

      HINT:
      Previous CAN communication system DTCs may be the cause if CAN communication system DTCs are output and all ECUs and sensors connected to the CAN communication system are displayed on the intelligent tester "Communication Bus Check" screen.


    NEXT


    6.CIRCUIT INSPECTION

      NEXT


      7.IDENTIFICATION OF PROBLEM

        NEXT


        8.REPAIR OR REPLACE

          NEXT


          9.CONFIRMATION TEST

            NEXT

            END