CAN COMMUNICATION SYSTEM (for LHD) > Skid Control ECU Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Skid Control ECU Communication Stop Mode |
|
|


| 1.CHECK OPEN IN CAN BUS WIRE (SKID CONTROL ECU BRANCH WIRE) |
Turn the ignition switch off.
Disconnect the skid control ECU connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Value |
| A25-26 (CANH) - A25-15 (CANL) | Ignition switch off | 54 to 69 Ω |
| Tester Connection | Condition | Specified Value |
| A26-11 (CANH) - A26-25 (CANL) | Ignition switch off | 54 to 69 Ω |
|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (IG1, GND1, GND2) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Value |
| A25-4 (GND1) - Body ground | Always | Below 1 Ω |
| A25-1 (GND2) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Value |
| A26-32 (GND1) - Body ground | Always | Below 1 Ω |
| A26-1 (GND2) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Value |
| A25-18 (IG1) - Body ground | Ignition switch on | 10 to 14 V |
| Tester Connection | Condition | Specified Value |
| A26-46 (IG1) - Body ground | Ignition switch on | 10 to 14 V |
|
| ||||
| OK | ||
| ||