POWER DOOR LOCK CONTROL SYSTEM > Front Passenger Side Door Lock Motor Circuit |


| 1.INSPECT FRONT DOOR LOCK ASSEMBLY (DOOR LOCK MOTOR) |
![]() |
Inspect LHD models.
Remove the front door lock assembly RH.
Apply battery voltage and check operation of the door lock motor.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 4 Battery negative (-) → Terminal 1 | Lock |
| Battery positive (+) → Terminal 1 Battery negative (-) → Terminal 4 | Unlock |
![]() |
Inspect RHD models.
Remove the front door lock assembly LH.
Apply battery voltage and check operation of the door lock motor.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 4 Battery negative (-) → Terminal 1 | Lock |
| Battery positive (+) → Terminal 1 Battery negative (-) → Terminal 4 | Unlock |
|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (FRONT DOOR LOCK - MAIN BODY ECU (INSTRUMENT PANEL J/B)) |
Disconnect the front door lock assembly connector.

Disconnect the ECU (instrument panel J/B) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection (Symbols) | Condition | Specified Condition |
|
(*1) M8-4 (L) - IJ-3 | Always | Below 1 Ω |
|
(*1) M8-1 (UL) - IJ-2 | Always | Below 1 Ω |
|
(*1) IJ-3 - Body ground | Always | 10 kΩ or higher |
|
(*1) IJ-2 - Body ground | Always | 10 kΩ or higher |
|
(*2) I7-4 (L) - IK-2 | Always | Below 1 Ω |
|
(*2) I7-1 (UL) - IJ-2 | Always | Below 1 Ω |
|
(*2) IK-2 - Body ground | Always | 10 kΩ or higher |
|
(*2) IJ-2 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||