Home › BODY › WINDSHIELD / WINDOWGLASS › WINDOW DEFOGGER SYSTEM

WINDOW DEFOGGER SYSTEM > REPAIR

for Preparation Click here



1. REPAIR WINDOW DEFOGGER WIRE


B106758E03
  1. Clean the broken wire tips with a grease, wax and silicone remover.

  1. Place the masking tape along both sides of the wire.



    B106759
  1. Thoroughly mix the repair agent (Dupont paste No. 4817 or equivalent).

  1. Using a fine tip brush, apply a small amount of the agent to the wire.

  1. After a few minutes, remove the masking tape.

    NOTICE:
    Do not repair the defogger wire again for at least 24 hours.