TIRE AND WHEEL SYSTEM > INSPECTION |
| 1. INSPECT TIRE |
Check the tires for wear and proper inflation pressure.
| Tire size | Front kPa (kgf*cm2, psi) | Rear kPa (kgf*cm2, psi) | |
| 215/60R16 95V | 4 passengers or less | 250 (2.5, 36)*1, 230 (2.3, 33)*2, 210 (2.1, 31)*3
| 250 (2.5, 36)*1, 230 (2.3, 33)*2, 210 (2.1, 31)*3
|
| 5 passengers | 270 (2.8, 39)*1, 250 (2.5, 36)*2, 220 (2.2, 32)*3
| 270 (2.8, 39)*1, 250 (2.5, 36)*2, 220 (2.2, 32)*3
| |
![]() |
Using a dial indicator, check the runout of the tires.
| 2. ROTATE TIRE |
![]() |
Rotate the tires as shown in illustration.
| 3. INSPECT WHEEL BALANCE |
![]() |
Check and adjust the off-the-car balance.
Steel wheel
If necessary, check and adjust the on-the-car balance.
Except for steel wheel
![]() |
If necessary, check and adjust the on-the-car balance.
| 4. INSPECT FRONT AXLE HUB BEARING LOOSENESS |
![]() |
Using a dial indicator, check for looseness near the center of the axle hub.
| 5. INSPECT REAR AXLE HUB BEARING LOOSENESS |
![]() |
Using a dial indicator, check for looseness near the center of the axle hub.
| 6. INSPECT FRONT AXLE HUB RUNOUT |
![]() |
Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.
| 7. INSPECT REAR AXLE HUB RUNOUT |
![]() |
Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.