Home › BODY › ENGINE HOOD / DOOR › REAR DOOR

REAR DOOR > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT REAR DOOR PANEL SUB-ASSEMBLY


  1. Check that the clearance measurements of areas A through L are within each standard range.


    B132825E01


    Standard clearance:

    Area
    Measurement
    Area
    Measurement
    A
    2.7 to 5.7 mm (0.106 to 0.224 in.)
    G
    3.3 to 6.3 mm (0.130 to 0.248 in.)
    B
    -1.5 to 1.5 mm (-0.059 to 0.059 in.)
    H
    0 to 3.0 mm (0 to 0.118 in.)
    C
    2.3 to 6.3 mm (0.091 to 0.248 in.)
    I
    3.3 to 6.3 mm (0.130 to 0.248 in.)
    D
    -2.0 to 2.0 mm (-0.079 to 0.079 in.)
    J
    5.7 to 8.7 mm (0.224 to 0.343 in.)
    E
    3.3 to 6.3 mm (0.130 to 0.248 in.)
    K
    2.7 to 5.7 mm (0.106 to 0.224 in.)
    F
    -0.3 to 2.7 mm (0.012 to 0.106 in.)
    L
    -1.5 to 1.5 mm (-0.059 to 0.059 in.)