DTC P0504 Brake Switch "A" / "B" Correlation |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0504 | Conditions (a) and (b) continue for 0.5 seconds or more (1 trip detection logic): (a) Ignition switch to ON (b) STP signal is off when ST1- signal is off |
|

| Brake Pedal Operation | Specified Condition |
| Depressed | STP signal on |
| Released | STP signal off |
| 1.CHECK STOP LIGHT SWITCH ASSEMBLY (TERMINAL VOLTAGE) |
![]() |
Disconnect the stop light switch assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A19-2 - Body ground | Always | 11 to 14 V |
| *1 | Front view of wire harness connector (to Stop Light Switch Assembly) |
Reconnect the stop light switch assembly connector.
|
| ||||
| OK | |
| 2.CHECK STOP LIGHT SWITCH ASSEMBLY (TERMINAL VOLTAGE) |
![]() |
Disconnect the stop light switch assembly connector.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A19-4 - Body ground | Ignition switch ON | 11 to 14 V |
| *1 | Front view of wire harness connector (to Stop Light Switch Assembly) |
Reconnect the stop light switch assembly connector.
|
| ||||
| OK | |
| 3.INSPECT STOP LIGHT SWITCH ASSEMBLY |
![]() |
Remove the stop light switch assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Position | Specified Condition |
| 1 - 2 | Switch pin not pushed | Below 1 Ω |
| Switch pin pushed | 10 kΩ or higher | |
| 3 - 4 | Switch pin not pushed | 10 kΩ or higher |
| Switch pin pushed | Below 1 Ω |
Reinstall the stop light switch assembly.
|
| ||||
| OK | |
| 4.CHECK ECM (STP AND ST1- VOLTAGE) |
![]() |
Disconnect the ECM connector.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A24-35 (ST1-) - Body ground | Brake pedal released | 7.5 to 14 V |
| Brake pedal depressed | 0 to 1.5 V | |
| A24-36 (STP) - Body ground | Brake pedal released | 0 to 1.5 V |
| Brake pedal depressed | 7.5 to 14 V |
Reconnect the ECM connector.
|
| ||||
| OK | ||
| ||