Home › ENGINE · 2GR-FE › STARTING › ENTRY AND START SYSTEM

DTC    B2287    LIN Communication Master Malfunction

for Preparation Click here


DESCRIPTION

This DTC is output when there is a LIN communication problem between the main body ECU and certification ECU.

HINT:
When the main body ECU is replaced with a new one and the negative (-) battery terminal is connected, the power source mode becomes the IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
After the main body ECU or certification ECU is replaced, perform the registration procedures for the engine immobiliser system.


DTC No.
DTC Detection Condition
Trouble Area
B2287
Communication or communication line is abnormal between the main body ECU and the certification ECU
  1. Main body ECU
  2. Certification ECU
  3. Wire harness or connector

B137997E05


WIRING DIAGRAM


B137989E23


INSPECTION PROCEDURE

1.CHECK FOR DTCS
  1. Clear the DTCs (Click here).

  1. Check for DTC B2287 and B2785.

    Result:
    Display (DTC output)
    Proceed to
    "DTC B2287" and "DTC B2785"
    A
    "DTC B2287" only
    B
    No DTC
    C



B
REPLACE CERTIFICATION ECU

C
USE SIMULATION METHOD TO CHECK (Click here)
A


2.CHECK WIRE HARNESS (MAIN BODY ECU - CERTIFICATION ECU)


  1. Disconnect the E74 and IR ECU connectors.


    B184301E03

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    IR-9 (LIN1) - E74-10 (LIN)
    Always
    Below 1 Ω
    IR-9 (LIN1) or E74-10 (LIN) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK MAIN BODY ECU OPERATION
  1. After replacing the main body ECU with a normally functioning ECU, check that the engine starts (Click here).

    OK:
    Engine can start normally.



NG
REPLACE CERTIFICATION ECU
OK

END (MAIN BODY ECU WAS DEFECTIVE)