Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › AIRBAG SYSTEM

AIRBAG SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


The intelligent tester can be used in steps 3, 5, 7, 9, and 10.


1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS
    1. Confirm problem symptoms (Click here).


    NEXT


    3.CHECK CAN COMMUNICATION SYSTEM
    1. Check for DTC outputs.

      HINT:
      The center airbag sensor assembly is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN communication system.

    2. Result:
      Result
      Proceed To
      CAN communication DTC is not output.
      A
      CAN communication DTC is output.
      B



    B.
    INSPECT CAN COMMUNICATION CIRCUIT
    A


    4.WARNING LIGHT CHECK

      NEXT


      5.CHECK DTC (Present and Past DTCs)
      1. Check for DTC outputs.

      2. Result:
        Result
        Proceed To
        DTC is output.
        A
        DTC is not output.
        B



      B.
      PROBLEM SYMPTOMS TABLE
      A


      6.DTC CHART

        NEXT


        7.CIRCUIT INSPECTION

          NEXT


          8.REPAIR

            NEXT


            9.CLEAR DTC (Present and Past DTCs)

              NEXT


              10.CHECK DTC (Present and Past DTCs)
              1. Check for DTC outputs.

              2. Result:
                Result
                Proceed To
                DTC is not output.
                A
                DTC is output.
                B



              B.
              Go to step 6
              A


              11.CONFIRMATION TEST

                NEXT

                END