DTC P0351 Ignition Coil "A" Primary / Secondary Circuit |
DTC P0352 Ignition Coil "B" Primary / Secondary Circuit |
DTC P0353 Ignition Coil "C" Primary / Secondary Circuit |
DTC P0354 Ignition Coil "D" Primary / Secondary Circuit |
DTC P0355 Ignition Coil "E" Primary / Secondary Circuit |
DTC P0356 Ignition Coil "F" Primary / Secondary Circuit |

| DTC No. | DTC Detection Condition | Trouble Area |
| P0351 P0352 P0353 P0354 P0355 P0356 | No IGF signal to ECM while engine is running (1 trip detection logic) |
|
![]() |
| Item | Content |
| Terminals | CH1: IGT1, IGT2, IGT3, IGT4, IGT5, IGT6 - E1 CH2: IGF1 - E1 |
| Equipment Settings | 2 V/DIV. 20 ms./DIV. |
| Conditions | Cranking or idling |


| 1.INSPECT IGNITION COIL ASSEMBLY (POWER SOURCE) |
![]() |
Disconnect the C11, C13, C12, C14, C38 or C39 ignition coil connector.
Turn the ignition switch to the ON position.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| C11-1 - Body ground | 9 to 14 V |
| C13-1 - Body ground | 9 to 14 V |
| C12-1 - Body ground | 9 to 14 V |
| C14-1 - Body ground | 9 to 14 V |
| C38-1 - Body ground | 9 to 14 V |
| C39-1 - Body ground | 9 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| C11-4 - Body ground | Below 1 Ω |
| C13-4 - Body ground | Below 1 Ω |
| C12-4 - Body ground | Below 1 Ω |
| C14-4 - Body ground | Below 1 Ω |
| C38-4 - Body ground | Below 1 Ω |
| C39-4 - Body ground | Below 1 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (IGNITION COIL ASSEMBLY - ECM (IGT SIGNAL TERMINAL)) |
![]() |
Disconnect the C11, C13, C12, C14, C38 or C39 ignition coil connector.
Disconnect the ECM C58 (RHD) or C55 (LHD) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| IGT1 (C11-3) - IGT1 (C58-40) | Below 1 Ω |
| IGT2 (C13-3) - IGT2 (C58-39) | Below 1 Ω |
| IGT3 (C12-3) - IGT3 (C58-38) | Below 1 Ω |
| IGT4 (C14-3) - IGT4 (C58-37) | Below 1 Ω |
| IGT5 (C38-3) - IGT5 (C58-36) | Below 1 Ω |
| IGT6 (C39-3) - IGT6 (C58-35) | Below 1 Ω |
| Tester Connection | Specified Condition |
| IGT1 (C11-3) - IGT1 (C55-40) | Below 1 Ω |
| IGT2 (C13-3) - IGT2 (C55-39) | Below 1 Ω |
| IGT3 (C12-3) - IGT3 (C55-38) | Below 1 Ω |
| IGT4 (C14-3) - IGT4 (C55-37) | Below 1 Ω |
| IGT5 (C38-3) - IGT5 (C55-36) | Below 1 Ω |
| IGT6 (C39-3) - IGT6 (C55-35) | Below 1 Ω |
| Tester Connection | Specified Condition |
| IGT1 (C11-3) or IGT1 (C58-40) - Body ground | 10 kΩ or higher |
| IGT2 (C13-3) or IGT2 (C58-39) - Body ground | 10 kΩ or higher |
| IGT3 (C12-3) or IGT3 (C58-38) - Body ground | 10 kΩ or higher |
| IGT4 (C14-3) or IGT4 (C58-37) - Body ground | 10 kΩ or higher |
| IGT5 (C38-3) or IGT5 (C58-36) - Body ground | 10 kΩ or higher |
| IGT6 (C39-3) or IGT6 (C58-35) - Body ground | 10 kΩ or higher |
| Tester Connection | Specified Condition |
| IGT1 (C11-3) or IGT1 (C55-40) - Body ground | 10 kΩ or higher |
| IGT2 (C13-3) or IGT2 (C55-39) - Body ground | 10 kΩ or higher |
| IGT3 (C12-3) or IGT3 (C55-38) - Body ground | 10 kΩ or higher |
| IGT4 (C14-3) or IGT4 (C55-37) - Body ground | 10 kΩ or higher |
| IGT5 (C38-3) or IGT5 (C55-36) - Body ground | 10 kΩ or higher |
| IGT6 (C39-3) or IGT6 (C55-35) - Body ground | 10 kΩ or higher |
| Tester Connection | Specified Condition |
| IGF (C11-2) - IGF1 (C58-106) | Below 1 Ω |
| IGF (C13-2) - IGF1 (C58-106) | Below 1 Ω |
| IGF (C12-2) - IGF1 (C58-106) | Below 1 Ω |
| IGF (C14-2) - IGF1 (C58-106) | Below 1 Ω |
| IGF (C38-2) - IGF1 (C58-106) | Below 1 Ω |
| IGF (C39-2) - IGF1 (C58-106) | Below 1 Ω |
| Tester Connection | Specified Condition |
| IGF (C11-2) - IGF1 (C55-106) | Below 1 Ω |
| IGF (C13-2) - IGF1 (C55-106) | Below 1 Ω |
| IGF (C12-2) - IGF1 (C55-106) | Below 1 Ω |
| IGF (C14-2) - IGF1 (C55-106) | Below 1 Ω |
| IGF (C38-2) - IGF1 (C55-106) | Below 1 Ω |
| IGF (C39-2) - IGF1 (C55-106) | Below 1 Ω |
| Tester Connection | Specified Condition |
| IGF (C11-2) or IGF1 (C58-106) - Body ground | 10 kΩ or higher |
| IGF (C13-2) or IGF1 (C58-106) - Body ground | 10 kΩ or higher |
| IGF (C12-2) or IGF1 (C58-106) - Body ground | 10 kΩ or higher |
| IGF (C14-2) or IGF1 (C58-106) - Body ground | 10 kΩ or higher |
| IGF (C38-2) or IGF1 (C58-106) - Body ground | 10 kΩ or higher |
| IGF (C39-2) or IGF1 (C58-106) - Body ground | 10 kΩ or higher |
| Tester Connection | Specified Condition |
| IGF (C11-2) or IGF1 (C55-106) - Body ground | 10 kΩ or higher |
| IGF (C13-2) or IGF1 (C55-106) - Body ground | 10 kΩ or higher |
| IGF (C12-2) or IGF1 (C55-106) - Body ground | 10 kΩ or higher |
| IGF (C14-2) or IGF1 (C55-106) - Body ground | 10 kΩ or higher |
| IGF (C38-2) or IGF1 (C55-106) - Body ground | 10 kΩ or higher |
| IGF (C39-2) or IGF1 (C55-106) - Body ground | 10 kΩ or higher |
Reconnect the ignition coil connector.
Reconnect the ECM connector.
|
| ||||
| OK | |
| 3.PERFORM SIMULATION TEST |
Clear the DTC(s) (Click here).
Change the arrangement of the ignition coils (with igniters).
Perform a simulation test.
| Display (DTC Output) | Proceed to |
| Same DTCs (that have been erased) | A |
| Other DTCs | B |
|
| ||||
| A | ||
| ||