Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
The intelligent tester can be used at steps 3, 7, and 10.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS
    1. Interview the customer and confirm the trouble (Click here).


    NEXT


    3.CHECK DTC AND FREEZE FRAME DATA
    1. Check and record a DTC and Freeze Frame Data.

    2. Clear the DTC and Freeze Frame Data (Click here).

    3. Reconfirm the DTC.

      1. Reconfirm the DTC based on the recorded DTC and Freeze Frame Data (Click here for DTC Check/Clear, and Click here for Freeze Frame Data).

        HINT:
        If any of the DTCs U0100/65, U0123/62, U0124/95, and U0126/63 is output together with a CAN communication DTC, first check the appropriate sensor for a momentary open circuit (Click here).


        Result:

        Condition
        Proceed to
        DTC is output
        A
        DTC is not output (Problem symptom does not occur)
        B
        DTC is not output (Problem symptom occurs)
        C



    B.
    GO TO STEP 5

    C.
    GO TO STEP 6
    A


    4.DIAGNOSTIC TROUBLE CODE CHART
    1. Proceed to Diagnostic Trouble Code Chart (Click here).


    NEXT

    GO TO STEP 7


    5.SYMPTOM SIMULATION
    1. Proceed to Diagnosis System (Click here).


    NEXT


    6.PROBLEM SYMPTOMS TABLE
    1. Proceed to Problem Symptoms Table (Click here).


    NEXT


    7.CIRCUIT INSPECTION

      NEXT


      8.IDENTIFICATION OF PROBLEM

        NEXT


        9.REPAIR OR REPLACEMENT

          NEXT


          10.CONFIRMATION TEST

            NEXT

            END