VEHICLE STABILITY CONTROL SYSTEM > DIAGNOSIS SYSTEM |
| DESCRIPTION |
Check the battery voltage.
![]() |
Check the DLC3.
The ECU uses ISO 15765-4 for communication. The terminal arrangement of the DLC3 complies with ISO 15031-3 and matches the ISO 15765-4 format.
If the result is not as specified, the DLC3 may have a malfunction. Repair or replace the harness and connector.
Verify the conditions listed in the table below.
| Symbols (Terminal No.) | Terminal Description | Condition | Specified condition |
| SIL (7) - SG (5) | Bus "+" line | During transmission | Pulse generation |
| CG (4) - Body ground | Chassis ground | Always | Below 1 Ω |
| SG (5) - Body ground | Signal ground | Always | Below 1 Ω |
| BAT (16) - Body ground | Battery positive | Always | 11 to 14 V |
| CANH (6) - CANL (14) | CAN bus line | *Ignition switch off | 54 to 69 Ω |
| CANH (6) - CG (4) | HIGH-level CAN bus line | *Ignition switch off | 200 Ω or higher |
| CANL (14) - CG (4) | LOW-level CAN bus line | *Ignition switch off | 200 Ω or higher |
| CANH (6) - BAT (16) | HIGH-level CAN bus line | *Ignition switch off | 6 kΩ or higher |
| CANL (14) - BAT (16) | LOW-level CAN bus line | *Ignition switch off | 6 kΩ or higher |
| DIAGNOSIS |
![]() |
If the skid control ECU detects a malfunction, the ABS warning, BRAKE warning and SLIP indicator lights will come on in order to warn the driver.
The DTCs are simultaneously stored in the memory. The DTCs can be read by connecting the SST between terminals TC and CG of the DLC3 and observing the blinking pattern of the ABS warning and SLIP indicator lights, by reading the multi information display, or by connecting the intelligent tester.
This system has a Test Mode (signal check) function (Click here).
The DTC can be read by connecting the intelligent tester and observing the blinking pattern of the ABS warning and SLIP indicator lights, by reading the multi information display.
| WARNING LIGHT AND INDICATOR LIGHT CHECK |
![]() |
Release the parking brake.
When the ignition switch is turned on (IG), check that the ABS warning, BRAKE warning and SLIP indicator lights come on for approximately 3 seconds.
| Trouble Area | See procedure |
| ABS warning light circuit |
Click here
|
| BRAKE warning light circuit |
Click here
|
| SLIP indicator light circuit |
Click here
|
| SYMPTOM SIMULATION |
![]() |
Vibration method: When vibration seems to be the major cause.
Slightly vibrate the part of the sensor considered to be the problem cause with your fingers and check whether the malfunction occurs.
Slightly shake the connector vertically and horizontally.
Slightly shake the wire harness vertically and horizontally. The connector joint and fulcrum of the vibration are the major areas to be checked thoroughly.