VEHICLE STABILITY CONTROL SYSTEM > CALIBRATION |
| DESCRIPTION |
| Replacing Parts / Operation | Necessary Operation |
| Brake actuator assembly (Skid control ECU) | Yaw rate and acceleration sensor zero point calibration. |
| Yaw rate and acceleration sensor |
|
| Front wheel alignment adjustment |
|
| OBTAIN ZERO POINT OF YAW RATE AND ACCELERATION SENSOR (INTELLIGENT TESTER) |
![]() |
Clear the zero point calibration data.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Check that the steering wheel is centered and move the shift lever to the P position (A/T) or apply the parking brake (M/T).
Turn the ignition switch on (IG).
![]() |
Operate the intelligent tester to erase the codes (select "Reset Memory").
Turn the ignition switch off.
Perform zero point calibration of the yaw rate and acceleration sensor.
Turn the ignition switch off.
Check that the steering wheel is centered and move the shift lever to the P position (A/T) or apply the parking brake (M/T).
![]() |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
![]() |
Set the intelligent tester to Test Mode (select "Test Mode").
After the Test Mode has been entered, keep the vehicle stationary on a level surface for 2 seconds or more.
![]() |
Check that the ABS warning and SLIP indicator lights come on for several seconds and then blink in the Test Mode blinking pattern.
Turn the ignition switch off and disconnect the intelligent tester.
| OBTAIN ZERO POINT OF YAW RATE AND ACCELERATION SENSOR (SST CHECK WIRE) |
![]() |
Clear the zero point calibration data.
Turn the ignition switch off.
Check that the steering wheel is centered and move the shift lever to the P position (A/T) or apply the parking brake (M/T).
Turn the ignition switch on (IG).
The warning light and indicator light come on for 3 seconds to indicate that the initial check is completed.
Using SST, connect and disconnect terminals TS and CG of the DLC3 4 times or more within 8 seconds.
Perform zero point calibration of the yaw rate and acceleration sensor.
Turn the ignition switch off.
Check that the steering wheel is centered and move the shift lever to the P position (A/T) or apply the parking brake (M/T).
![]() |
Using SST, connect terminals TS and CG of the DLC3.
Turn the ignition switch on (IG).
Keep the vehicle stationary on a level surface for 2 seconds or more.
![]() |
Check that the ABS warning and SLIP indicator lights come on for several seconds and then blink in the Test Mode blinking pattern.
Turn the ignition switch off and disconnect the SST from the DLC3.