Component
| Function
|
Engine Switch
- Transponder Key Amplifier
| - Transmits engine switch signal to main body ECU.
- Informs driver of power source mode or system abnormality with illumination of indicator light.
- Receives ID code and transmits it to certification ECU when key battery is low.
|
Electrical Key
| Receives signals from oscillators and returns ID code to door control receiver.
|
Electrical Key Oscillator
- Console and Rear Seat
| Receives request signals from certification ECU and forms detection area in vehicle interior.
|
Steering Lock ECU
| Receives lock/unlock request signals from certification ECU and main body ECU.
|
Door Control Receiver
| Receives ID code from electrical key and transmits it to certification ECU.
|
Main body ECU
| - Changes power source mode in 4 stages (off, on (ACC), on (IG), start) in accordance with shift position and state of stop light switch.
- Controls push-button start function in accordance with signals received from switches and each ECU.
|
Certification ECU
| Certifies ID code received from door control receiver and transmits certification results to ID code box and steering lock ECU.
|
Stop Light Switch
| Outputs state of brake pedal to main body ECU.
|
ID Code Box
| Receives steering unlock or engine immobiliser unset signals from certification ECU, certifies them, and transmits each unset signal to steering lock ECU or ECM.
|
ECM
| - Receives engine start request signal from main body ECU, turns ON ST relay, and starts engine.
- Receives signal from ID code box and performs engine ignition and injection.
|
To operate the push-button start function when the key battery is low, hold the key close to the engine switch with the brake pedal depressed.
The main body ECU transmits a key verification request signal from the stop light switch to the certification ECU.
The certification ECU does not receive an ID code response from the entry door control receiver, so it actuates the transponder key amplifier built into the engine switch.
The transponder key amplifier outputs an engine immobiliser radio wave to the key.
The key receives the radio wave, and returns a radio wave response to the transponder key amplifier.
The transponder key amplifier combines the key ID codes with the radio wave response, and transmits it to the certification ECU.
The certification ECU judges and verifies the ID code, and transmits a key verification OK signal to the main body ECU. The buzzer in the combination meter sounds at the same time.
After the buzzer sounds, if the engine switch is pressed within 5 seconds with the brake pedal not depressed, the power source mode changes to on (ACC) or on (IG), the same as in the normal condition.