DTC C1231/31 Steering Angle Sensor Circuit Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1231/31 | When ECU IG1 terminal voltage is 9.5 V or more, the steering angle sensor malfunction signal is received. |
|

| 1.CHECK DTC |
Clear the DTC (Click here).
Turn the ignition switch off.
Turn the ignition switch to the ON position again and check that no CAN communication system DTC is output.
Drive the vehicle and turn the steering wheel to the right and left at the speed of 22 mph (35 km/h) and check that no speed sensor and yaw rate sensor DTCs are output.
| Condition | Proceed to |
| No CAN communication system DTC and the speed sensor or yaw rate sensor DTC are output | A |
| CAN communication system DTC is output | B |
| Speed sensor or yaw rate sensor DTC is output | C |
|
| ||||
|
| ||||
| A | |
| 2.INSPECT STEERING ANGLE SENSOR (POWER SOURCE TERMINAL) |
![]() |
Turn the ignition switch off.
Remove the steering wheel and the column cover lower.
Disconnect the steering angle sensor connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E17-1 (IG) - Body ground | Ignition switch ON | 10 to 14 V |
| E17-3 (BAT) - Body ground | Always | 10 to 14 V |
|
| ||||
| OK | |
| 3.INSPECT STEERING ANGLE SENSOR (GROUND TERMINAL) |
![]() |
Turn the ignition switch off.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E17-2 (ESS) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||