Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > VSC Warning Light does not Come ON

for Preparation Click here


DESCRIPTION

The skid control ECU communicates with the combination meter via CAN communication. If the ECU stores a DTC, the DTC will be displayed on the multi information display in the combination meter.

WIRING DIAGRAM


C139990E01


INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly, perform zero point calibration (Click here).

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if the CAN communication system DTC is output (Click here for LHD, or Click here for RHD).

    Result:

    Condition
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
INSPECT CAN COMMUNICATION SYSTEM
A


2.CHECK VSC WARNING LIGHT
  1. Connect the intelligent tester to the DLC3.

  1. Start the engine.

  1. Select "VSC Warning Lamp" in the Active Test and operate the multi information display using the intelligent tester.

    ABS / VSC / TRC: 
    Item (Display)
    Vehicle Condition / Test Details
    Diagnostic Note
    VSC Warning Lamp
    Turn multi information display ON / OFF
    Observe combination meter

  1. Check that "ON" and "OFF" of the multi information display are indicated on the combination meter when using the intelligent tester.

    OK:
    The multi information display turns on or off in accordance with the intelligent tester.

    HINT:
    If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part (Click here).



OK
REPLACE BRAKE ACTUATOR ASSEMBLY
NG


3.INSPECT COMBINATION METER ASSEMBLY
  1. Turn the ignition switch off.

  1. Perform Active Test of the combination meter (meter CPU) using the intelligent tester (Click here).

    OK:
    The multi information display turns on or off in accordance with the intelligent tester.

    HINT:
    If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step (Click here).



NG
REPLACE COMBINATION METER ASSEMBLY
OK

REPLACE BRAKE ACTUATOR ASSEMBLY