ENTRY AND START SYSTEM > DIAGNOSIS SYSTEM |
| CHECK DLC3 |
![]() |
The vehicle ECU uses the ISO 15765-4 for communication protocol. The terminal arrangement of the DLC3 complies with ISO 15031-3 and matches the ISO 15765-4 format.
| Symbols (Terminal No.) | Terminal Description | Condition | Specified Condition |
| CG (4) - Body ground | Chassis ground | Always | Below 1 Ω |
| SG (5) - Body ground | Signal ground | Always | Below 1 Ω |
| BAT (16) - Body ground | Battery positive | Always | 9 to 14 V |
| CANH (6) - CANL (14) | CAN bus line | Engine switch off* | 54 to 69 Ω |
| CANH (6) - Battery positive | HIGH-level CAN bus line | Engine switch off* | 6 kΩ or higher |
| CANH (6) - CG (4) | HIGH-level CAN bus line | Engine switch off* | 200 Ω or higher |
| CANL (14) - Battery positive | LOW-level CAN bus line | Engine switch off* | 6 kΩ or higher |
| CANL (14) - CG (4) | LOW-level CAN bus line | Engine switch off* | 200 Ω or higher |
| INSPECT BATTERY VOLTAGE |
Measure the battery voltage.