DTC C1241/41 Low Battery Positive Voltage |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1241/41 | When any of the following is detected:
|
|

| 1.INSPECT ECU-IG NO. 2 FUSE |
![]() |
Remove the ECU-IG NO. 2 fuse from the main body ECU.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| ECU-IG NO. 2 (7.5 A) fuse | Always | Below 1 Ω |
|
| ||||
| OK | |
| 2.CHECK BATTERY |
Install the ECU-IG NO. 2 fuse.
Check the battery voltage.
|
| ||||
| OK | |
| 3.INSPECT SKID CONTROL ECU (IG1 TERMINAL) |
![]() |
Disconnect the skid control ECU connector.
Turn the ignition switch to the ON position.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A26-46 (IG1) - Body ground | Ignition switch ON | 10 to 14 V |
|
| ||||
| OK | |
| 4.INSPECT SKID CONTROL ECU (GND TERMINAL) |
![]() |
Turn the ignition switch off.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A26-32 (GND1) - Body ground | Always | Below 1 Ω |
| A26-1 (GND2) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 5.RECONFIRM DTC |
Reconnect the skid control ECU connector.
Clear the DTC (Click here).
Turn the ignition switch to the ON position.
Check if the same DTC is recorded (Click here).
| Condition | Proceed to |
| DTC (C1241/41) is not output | A |
| DTC (C1241/41) is output | B |
|
| ||||
| A | ||
| ||