STEERING LOCK SYSTEM > DATA LIST / ACTIVE TEST |
| DATA LIST |
Turn the engine switch off.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Entry & Start / Data List.
According to the display on the intelligent tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Slck Sleep Cond | Steering lock ECU sleep condition / YES or NO | YES: Steering lock ECU sleep mode can be entered NO: Steering lock ECU sleep mode cannot be entered | - |
| Slck Start Cond | Steering lock ECU start signal / YES or NO | YES: Steering lock ECU sent a start signal NO: Steering lock ECU did not send a start signal | - |
| Eng Start Cond | Engine start condition / OK or NG | OK: Engine is allowed to start NG: Engine is not allowed to start | - |
| Sensor Value | Sensor malfunction / NG (PAST) or OK | NG (PAST): Sensor malfunction OK: No malfunction | - |
| Pwr Supply Shrt | Short in ECU / NG (PAST) or OK | NG (PAST): Short in ECU OK: No malfunction | - |
| Pwr Supply Open | Open in ECU / NG (PAST) or OK | NG (PAST): Open in ECU OK: No malfunction | - |
| Mtr Driver Shrt | Short in driver ECU / NG (PAST) or OK | NG (PAST): Short in driver ECU OK: No malfunction | - |
| Mtr Driver Open | Open in driver ECU / NG (PAST) or OK | NG (PAST): Open in driver ECU OK: No malfunction | - |
| Lck/Unlck Rec | Steering lock command reception record / YES or NO | YES: Steering lock/unlock signal received NO: Steering lock/unlock signal no received | - |
| Lck Bar Stuck | Lock bar stuck malfunction / NG (PAST) or OK | NG (PAST): Lock bar stuck malfunction OK: No malfunction | - |
| Push Start Err | Push button start function malfunction / NG (PAST) or OK | NG (PAST): Malfunction in push button start OK: No malfunction | - |
| IG2 | IG2 voltage / ON or OFF | ON: 10 to 14 V OFF: Below 1 V | - |
| IG (Lin) | LIN bus IG status / ON or OFF | ON: LIN bus IG ON status OFF: LIN bus IG OFF status | - |
| ACTIVE TEST |
Turn the engine switch off.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Combination Meter / Active Test.
According to the display on the intelligent tester, perform the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Security Ind | Security Indicator | ON or OFF | - |