STEERING LOCK SYSTEM > Unlock Position Sensor Signal Circuit |

| 1.INSPECT STEERING LOCK ECU (STEERING LOCK ACTUATOR ASSEMBLY) |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E69-4 (SLP1) - E69-2 (SGND) |
| Below 1 V |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (STEERING LOCK ECU - MAIN BODY ECU) |
![]() |
Disconnect the E69 connector from the steering lock ECU.
Disconnect the E7 connector from the main body ECU.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E69-4 (SLP1) - E7-18 (SLP) | Always | Below 1 Ω |
| E69-4 (SLP1) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||