STEERING LOCK SYSTEM > Steering Lock Motor Drive Power Circuit |

| 1.CHECK VEHICLE CONDITION |
Check the problem symptom of the steering lock system.
| Condition | Proceed to |
| Steering lock cannot be released | A |
| Steering cannot be locked | B |
|
| ||||
| A | |
| 2.READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG), and turn the intelligent tester on.
Select the item below in the DATA LIST, and read its value displayed on the intelligent tester.
| Item | Measurement Item/Range | Normal Condition | Diagnostic Note |
| LCK/UNLCK REC | Steering lock command reception record / YES or NO | YES: Steering lock/unlock signal received NO: Steering lock/unlock signal not received | - |
Check if a steering unlock command signal has been received.
|
| ||||
| OK | |
| 3.INSPECT STEERING LOCK ECU (STEERING LOCK ACTUATOR ASSEMBLY) |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E69-3 (IGE) - E69-1 (GND) |
|
|
|
| ||||
| OK | ||
| ||
| 4.CHECK HARNESS AND CONNECTOR (STEERING LOCK ECU - BODY GROUND) |
![]() |
Disconnect the E69 connector from the steering lock ECU.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E69-1 (GND) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (STEERING LOCK ECU - MAIN BODY ECU) |
![]() |
Disconnect the E7 connector from the main body ECU.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E69-3 (IGE) - E7-19 (SLR+) | Always | Below 1 Ω |
| E69-3 (IGE) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||
| 6.INSPECT STEERING LOCK ECU (STEERING LOCK ACTUATOR ASSEMBLY) |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E69-3 (IGE) - E69-1 (GND) | The specified condition should be checked after performing the following:
|
|
|
| ||||
| OK | ||
| ||
| 7.CHECK HARNESS AND CONNECTOR (STEERING LOCK ECU - MAIN BODY ECU) |
![]() |
Disconnect the E69 connector from the steering lock ECU.
Disconnect the E7 connector from the main body ECU.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E69-3 (IGE) - E7-19 (SLR+) | Always | Below 1 Ω |
| E69-3 (IGE) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||