Home › ENGINE · 2AZ-FE › COOLING › COOLING FAN RELAY

COOLING FAN RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. COOLING FAN RELAY


    B060778E01
  1. Remove the relay from the engine room No. 2 relay block.

  1. Measure the resistance of the relay.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 Ω or higher
    3 - 5
    Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)

    1. If the result is not as specified, replace the relay.

  1. Install the relay to the engine room relay block No. 2.



2. COOLING FAN RELAY NO. 2


    A087121E01
  1. Remove the relay from the engine room No. 2 relay block.

  1. Measure the resistance of the relay.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 4
    Below 1 Ω
    3 - 5
    10 Ω or higher
    3 - 4
    10 Ω or higher
    (when battery voltage is applied to terminals 1 and 2)
    3 - 5
    Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)

    1. If the result is not as specified, replace the relay.

  1. Install the relay.



3. COOLING FAN RELAY NO. 3


    B060778E45
  1. Remove the relay from the engine room No. 2 relay block.

  1. Measure the resistance of the relay.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 Ω or higher
    3 - 5
    Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)

    1. If the result is not as specified, replace the relay.

  1. Install the relay.