Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on Driver Door Window Only)

POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on Driver Door Window Only) > DTC CHECK / CLEAR

for Preparation Click here



CHECK DTC
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch ON.

  3. Check the DTC(s).


CLEAR DTC
C131975E01
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch ON.

  3. Clear the DTCs.

  4. Check that "DTCs are cleared" is displayed.

    NOTICE:
    If any DTCs are output, troubleshoot those DTCs again.