FUEL INJECTOR > INSPECTION |
| 1. INSPECT FUEL INJECTOR ASSEMBLY |
![]() |
Measure the resistance between the injector terminals.
Inspect the injector injection volume.
![]() |
Connect SST (fuel tube connector) to SST (hose), then connect them to the fuel pipe (vehicle side).
Install the O-ring to the fuel injector.
![]() |
Connect SST (adapter and hose) to the injector, and hold the injector and union with SST (clamp).
Put the injector into the graduated cylinder.
Operate the fuel pump.
![]() |
Connect SST (wire) to the injector and the battery for 15 seconds, and measure the injection volume with the graduated cylinder. Test each injector 2 or 3 times.
![]() |
Inspect the fuel leakage.
Disconnect the SST (wire) tester probes from the battery and check the fuel leakage from the injector.
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal.
Remove the SST.
Disconnect the intelligent tester from the DLC3.
Reconnect the fuel inlet hose (rear fuel pipe) to the fuel main tube.