FUEL INJECTOR > REMOVAL |
| 1. DISCHARGE FUEL SYSTEM PRESSURE |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY |
![]() |
Disconnect the mass air flow meter connector (*1).
Disconnect the purge VSV connector (*2).
Disconnect the 2 purge VSV vacuum hoses (*3).
Disconnect the purge line hose from the clamp (*4).
![]() |
Disconnect the No. 2 ventilation hose from the air cleaner hose.
![]() |
Lock the No. 1 air cleaner hose clamp, and then disconnect the No. 1 air cleaner hose from the throttle body.
![]() |
Remove the 2 bolts and air cleaner cap.
Remove the air cleaner filter element from the air cleaner case.
| 4. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY |
![]() |
Remove the 2 nuts and cover.
| 5. DISCONNECT FUEL TUBE SUB-ASSEMBLY |
![]() |
Remove the No. 1 fuel pipe clamp.
![]() |
If the connector and pipe are stuck, pinch the connector, and push and pull the pipe to disconnect them.
![]() |
Separate the fuel tube from the fuel hose clamp.
| 6. DISCONNECT NO. 2 VENTILATION HOSE |
![]() |
Disconnect the No. 2 ventilation hose from the ventilation valve.
| 7. REMOVE FUEL DELIVERY PIPE WITH INJECTOR |
![]() |
Remove the 2 wire harness clamps.
Disconnect the 4 fuel injector connectors.
![]() |
Remove the 2 bolts, then remove the fuel delivery pipe together with the 4 fuel injectors.
![]() |
Remove the 2 delivery pipe spacers from the cylinder head.
Remove the 4 insulators from the cylinder head.
| 8. REMOVE FUEL INJECTOR ASSEMBLY |
![]() |
Pull out the 4 injectors from the delivery pipe.
Remove the 4 O-rings from the injectors.